Our Work | Boiler & Heating Installations Leeds | Gas Engineer To The Rescue Leeds

Boiler installations

Combis, system boilers and full changeovers.

Viessmann wall mounted boiler with copper pipework, isolation valves and a system filter — **Viessmann boiler, full re-pipe**Flow and return dropped, isolation valves on every leg and a filter on the return before commissioning.

Worcester boiler with copper pipework, service valves and a MagnaClean filter — **Worcester install with MagnaClean**Four legs run and labelled, filter teed into the return and the gauge sighted so it can actually be read.

Vaillant ecoFIT pure combi boiler with copper pipework and condensate pipe — **Vaillant ecoFIT changeover**Old boiler out, new one hung and piped, condensate run to a proper termination.

Alpha combi boiler installed in a loft on a ply board with insulated pipework and a CO alarm — **Combi in a loft space**Alpha combi boarded, boiler-mounted on ply, pipework insulated and a CO alarm fitted alongside.

Wall mounted boiler in a cellar with a MagnaClean filter and grey insulated pipework — **Cellar boiler install**Hung clear of the wall, flue routed through and a filter fitted where it can actually be serviced.

Worcester boiler installed on a stud wall with copper pipework and a magnetic filter — **Boiler on an open stud wall**Piped and filtered while the wall was still open, so nothing had to be chased in afterwards.

New Ideal combi boiler installed on a plastered wall with copper pipework — **Combi changeover**Ideal combi in and commissioned, gas and water connections renewed rather than reused.

New white boiler flue run and wall terminal fitted above a boiler — **Flue re-route**New run out through the wall on a replacement, sealed and supported to spec.

Cylinders & plant rooms

Stored hot water, vessels, manifolds and the controls that run them.

Vaillant system boiler beside a Tempest unvented hot water cylinder with insulated pipework — **Boiler and unvented cylinder**Vaillant system boiler beside a Tempest cylinder, vessel and controls, all inside one airing cupboard.

Worcester system boiler and unvented hot water cylinder with expansion vessels — **System boiler and cylinder**What goes in when one combi was never going to feed two bathrooms at once.

Plant room with an OSO hot water cylinder, buffer vessel and insulated pipework — **Plant room, cylinder and buffer**OSO cylinder and buffer vessel with the primaries insulated and labelled throughout.

Underfloor heating manifold with expansion vessel, pumps and copper pipework in a plant room — **Underfloor manifold and plant**Manifold, expansion vessel, pumps and zone controls all on one wall and all reachable.

Heating control board with a Grundfos pump, MagnaClean filter, two zone valves and an EPH programmer — **Two-zone control board**Pump, filter, both zone valves and the programmer set out on one board so faults can be found in minutes.

Copper heating pipework on a board with a magnetic filter, valves and pressure gauge — **Plant board**Filter, gauges and valves laid out where they can be read and serviced, not buried in a corner.

Vaillant heating pump with brass isolation valves and copper pipework in a cellar — **Pump and valve assembly**Vaillant pump, isolation either side and a drain point, so the next service does not mean draining the house.

Radiators & pipework

Panels, columns, restored cast iron and the copper feeding them.

Two tall anthracite column radiators fitted in a period room — **Anthracite column radiators**Tall columns on a period property, tails dropped through the floor so nothing runs along the skirting.

Ornate gold painted cast iron column radiator — **Restored cast iron radiator**Ornate cast iron rad refitted and valved — heavy, beautiful, and needs the floor checked before it goes back.

White column radiator fitted under a window — **Column rad under a bay**Traditional radiator with valves and tails renewed at the same time.

Tall anthracite vertical designer radiator fitted in a hallway — **Vertical rad, narrow hall**Anthracite panel where nothing horizontal would have fitted.

Anthracite flat panel radiator with chrome pipework in a hallway — **Convector replaced**Flat panel in, pipework dropped and clipped rather than run along the skirting.

Navy vertical designer radiator with copper brackets in a bathroom — **Designer rad in a bathroom**Plumbed into the circuit and balanced with the rest of the system.

Brushed gold ladder towel rail fitted in a tiled bathroom — **Heated towel rail**On the heating circuit and balanced, not just hung on the wall and hoped for.

Copper heating pipes clipped neatly along a wall — **Primaries clipped and run**Straight runs, even clip spacing, nothing resting on a joist to knock when it warms up.

Wet underfloor heating pipework laid across a floor before screeding — **Underfloor pipe, pre-screed**Clipped out, pressure tested and left under pressure while the screed went over it.

Boiler with copper pipework, magnetic filter and a pressure gauge reading 1.5 bar — **Cleaned and set at 1.5 bar**Filter fitted, system flushed and pressure set before anybody signed it off.

Safety work

Not every job ends with something shiny on the wall.

Gas boiler with a Danger Do Not Use safety warning notice attached after an inspection — **Appliance classified and capped**A warning notice fitted after a gas safety inspection. If an appliance is unsafe it gets labelled and disconnected, not quietly left running.

Reviews

What the customers said

Reproduced word for word from customer reviews of To The Rescue — nothing rewritten, nothing tidied up.

★★★★★

Perfect professional service when my boiler was working fitted a new one the next day great price
Used again to get my bathroom fitted
Very clean and tidy reliable and very hardworking will use again

★★★★★

Had a great experience and would 100% recommend! We had a leak in our washer and a previous leak under the bathroom sink. The team was able to address both issues and also caught a small leak in our washer hose that could have caused problems later. You can tell they put a lot of honesty and care into their work. We’ve had our fair share of bad plumber experiences, but with them, we really appreciated how we were shown the root of each problem and kept informed throughout. They also made sure to test everything multiple times to ensure the issues were fully resolved.

★★★★★

Amazing service from this company today. Was in desperate need of rescuing and they came out super quickly to solve the issue. They were extremely polite, clean and couldn’t have been more helpful. Highly recommended 🙏

★★★★★

Very professional and great service.The leak was fixed promptly and with minimal mess.I would highly recommend their services to anyone needing a plumber

★★★★★

best plumbers they fixed my sink and made me and my parents very happy for the great service!

Get in touch

Book a quote

Ring and you get a Gas Safe registered engineer on the phone, not a script. Rather write it down? The form comes straight to our inbox.

Call us, any hour

0113 490 0490

No heat, no hot water or a boiler locked out — ring rather than email.

Hours24 hours a day, 7 days a week — bank holidays included
Emailinfo@plumbertotherescue.co.uk
AreaLeeds and the surrounding areas
RegistrationAll gas work by a Gas Safe registered engineer

Send us the details

No obligation. We’ll tell you honestly whether it’s a repair or a replacement.

26 jobs, all our own photographs

Combis, system boilers and full changeovers.

Stored hot water, vessels, manifolds and the controls that run them.

Panels, columns, restored cast iron and the copper feeding them.

Not every job ends with something shiny on the wall.

No heating, no hot water, or a smell of gas?

What the customers said

Book a quote

Send us the details